Assembly Instructions
Document #: 179717
REVISED: 11/2021
14-A.
This step is for 58001 and 58005 only, all other models skip to step 14-B.
Remove all components from inside 19179 before inverting. Remove panel A assembly and set to
the side. Position 19179 the metal flanges should touch the metal components as shown below,
install 8x fastener #1 on the two side flanges as shown.
Reference Line / Parallel edge
No fasteners on
this back tab
These edges
will touch
13. Edge of item #1 should be parallel with the reference line as shown (depending on the assembly
process the reference line may not be flush with the edge of item #1) Align edge of tube from item #1
with the edge of the wood, NOT the face of the edge banding. Fasten #1 to panel H using 8x fastener
#1 and then faster item #9 to panel H using 3x fastener #1.
Align edge of tube from item #1 with the edge of the
wood(brown surface), NOT the face of the edge banding.
