Edges of panel C and item #1 should
be parallel, the gap should be as
minimal as possible, check top and
bottom before fully fastening.
Assembly Instructions
Document #: 179717
REVISED: 11/2021
12. Place the previously assembled item #1 and panel B as shown. Attach item #8 using 2x fastener
#1 to panel C and attached item #8 to item #1 using 2x fastener #3, finger tighten only. Confirm the
gap between item #1 and panel C is constant and as minimal as possible as shown below. Fully
tighten fasteners.
11. Align item #9’s edge with the reference line as shown. Item #10 can be used as a spacer for panel
C. Insert panel C into the slot of Item #12. Place item #9 against panel C as show. Confirm that all 3x
holes on item #12 and item #9 can be seen though the slots while item #10 is in place. Fasten #12 and
#9 to panel C using 3x fastener #1 each. (Do not fasten item #9 to the panel H, this will be done in
further steps)
Reference line
Flush with #9’s edge
