2
3
smithandnoble.com
800.248.8888
SETTINGS MOTOR
CHANNEL
DISPLAY
OPEN
STOP/
FAVORITES
CLOSE
CHANNEL UP
CHANNEL DOWN
REMOTE FRONT
SETTING ROD LIMITS
OPERATING THE REMOTE
Open and Close Drapes
Select the desired channel with the
CHANNEL button.
Press the UP or DOWN buttons to close
or open the drape(s).
Press the STOP button to stop the rod at
the desired position.
Adjust Rod Limits (If Desired)
The open and close limits have been
set at the factory. If you need to make
adjustments to the limits, follow the
instructions below.
Use the CHANNEL buttons to select
the channel for the rod that needs to be
adjusted. Then follow the directions below.
When adjusting one rod, the other rods
on that channel need to be temporarily
unpaired from the remote (see UNPAIR
THE REMOTE).
Once limits are adjusted, the other rods
will need to be re-paired to the channel
(see PAIR THE REMOTE).
If there is a single rod on the channel,
proceed to SETTING LIMITS.
CHANNEL
DISPLAY
OPEN
STOP/
FAVORITES
CLOSE
CHANNEL UP
CHANNEL DOWN
REMOTE FRONT
CHANNEL
DISPLAY
OPEN
STOP/
FAVORITES
CLOSE
CHANNEL UP
CHANNEL DOWN
REMOTE FRONT
HOW TO
OPERATE MOTORIZED
DRAPES
SCAN TO PLAY VIDEO
HOW TO
CHANGE SET LIMITS
SCAN TO PLAY VIDEO
PAIRING THE REMOTE
Your rod will need to be paired to the
remote prior to operating your rod.
See
Pair the Remote below.
Pair The Remote
This remote control has 15 channels.
Before pairing the remote, determine
which rod(s) you want on which channel.
All rods paired to a remote will also
automatically be programmed to the
“ALL” channel which is "0".
It is recommended to only pair one
rod per channel
unless it is absolutely
necessary to group rods other than the
"ALL" channel. This simplifies adjusting
limits and setting favorites.
If a battery is not already installed in the
remote, follow the instructions REPLACE
BATTERY IN REMOTE.
1. Select the channel you want to
program your rod/track. Press SETTING
button on the motor for 2 seconds. Once
you release it, the motor will beep once
and the light on motor will light up green.
2. Press the STOP button on the remote
for 2 seconds. The motor will sound
3 beeps. The motor has been paired
successfully.
NOTE:
If the STOP button is not pressed
within 10 seconds, the rod will exit the
paring mode automatically.
Repeat steps 1-2 to pair remaining rods
to the rest of the channels.
HOW TO
PAIR REMOTE
TO MOTOR
SCAN TO PLAY VIDEO
