- 14 -
This page shows the probe temperature (
℃
),output current (mA),the
distance value (m / ft can be changed in settings).
Note:
If the PV is select as level value,the installation height (H) must be set
NO less than (
≧
) the measured distance (D) value. If H is less than D,
then the PV Value and the words “Level” in the main measurement
page will keep flashing;except the distance value on the other
measurement information page , the level value and the output current
will not change.
The PLUR series can provide 6 relays which may be used for control
purposes. These relays are for light duty and should be used as signal
relays only, with control functions being performed by external control
relays.
4.2.2
Programming mode
In programming mode, user can setup parameters of the instrument.
In this state, the instrument displays the parameters set by the
user's
needs.
In
the
measurement
mode
user
pressing SEL+MOV together in short to enter the the main menu of the
programming mode.
Press INC to choose item down in cycle in menu.
Press SEL to enter the next level menu or program
Press SEL + MOV together in short to go back to the upper level menu,or
quit.
This instrument uses two level menu structure, menu structure is as
follows: