34
ALARM ID
DESCRIPTION
USER ACTION
AF:01
The water does not heat to
temperature in the set time.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
AF:05
Operating temperature sensor
TL1 has generated an
anomalous signal (sensor
"open").
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
AF:07
Drying temperature sensor TA1
has generated an anomalous
signal (sensor "open").
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
AF:09
Partial draining has not been
successful.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
AF:11
No cold water during the fill
cycle.
Check the water supply:
1.
Check that the intake tap is open.
2.
Check the water supply pressure.
3.
Check the position of the intake hoses.
Run the DEFAULT PROCEDURE described above. If the alarm
does not reset, run the RESET PROCEDURE.
AF:12
No hot water.
Check the hot water supply:
1.
Check that the intake tap is open.
2.
Check the water supply pressure.
3.
Check the position of the intake hoses.
Run the DEFAULT PROCEDURE described above. If the alarm
does not reset, run the RESET PROCEDURE.
AF:17
Cold water filling time not
correct.
Run the checks and procedures specified in AF:11.
AF:18
Hot water filling time too long.
The machine is taking too long
to fill with hot water.
Run the checks and procedures specified in AF:12.
AF:23
Not enough water. wash
chamber water level is
dropping.
Run the checks and procedures specified in AF:11.
Also check for leaks - check for water on the floor around the
machine.
If you find any leaks: immediately close all supply taps and
contact technical service.
AF:25
Water circuit malfunction.
User: run the DEFAULT PROCEDURE described above. If the
alarm does not reset, run the RESET PROCEDURE.
Then open the door and check that there is not too much
foam in the wash chamber (reduce the amount of rinse aid)
and that the wash chamber filter is clean (proceed as shown
in fig. 16).
AF:29
The wash chamber does not
drain in the set time.
Check the drain connection,
in particular that the height of the drain fittings meets the
specifications given, and check for kinks and restrictions
along the drain hose.
Check that the filter unit is clean – fig. 16
