Smeg SW260, Translation Of The Original Instructions

Page: 16 / 41

16
Detailed description
BUTTONS DESCRIPTION
On/Off
This button is enabled both with the door open and closed.
It turns the interface on/off, thus allowing the dishwasher to be operated.
Brief press: shows the remaining cycle time
Hold the button down for 2 seconds to turn on or off.
Once on, the dishwasher displays the program ID (e.g. “Pr 03”).
When the interface is switched off, the display reads “OFF”.
When the door is open the display shows four dashes and the other buttons are disabled.
If the dishwasher is switched off with water still in the wash chamber, “OFF” flashes; at the
end of the phase it is displayed steadily.
The dishwasher is still powered even with the interface turned off.
Auto Open – open door at end of cycle
This button sets the door open function - see below for restrictions when running a heat
disinfection cycle.
It is not enabled if the prewash and service cycles are selected.
It is an alternative to the Repeat function.
There is no need to press the button for every cycle; it remains set once pressed
Dry – drying (ONLY MODELS with dryer)
This button is used to set the drying function and is only active in programs which use this
option – see programs table.
It is an alternative to the Repeat function.
There is no need to press the button for every cycle; it remains set once pressed
Additional prewash (where applicable)
This button is used to set an additional cold prewash at the beginning of each cycle.
There is NO need to press the button for every cycle; it remains active once pressed.
Start/Pause
Starts a new cycle or pauses the current one.
When the cycle starts or pauses, a double beep will sound. This button can also be used to
confirm a dishwasher parameter during configuration (hold down for 2 seconds).
Drain
Once a wash cycle has terminated, pressing this button drains the water, runs a regeneration
cycle (where required) and automatically turns the dishwasher off.
Confirm with the start/pause button; the display will read “UnLo” (Unload).
With automatic regeneration, “OFF” and “R” will flash until the end of the phase.
Repeat (where applicable)
Pressing this button reuses the water from the most recent rinse for the next cycle's
wash to speed up operation, in programs which have this option. This function is not
available if you have selected drying or automatic open at end of cycle.
Open door