20
5.8
Selecting the washing program
Selecting the washing program
Select the program available, referring to the models and versions in the next point,
depending on the type of soiling and the amount of tableware loaded into the baskets
To run a program:
1.
If the dishwasher is off, switch it on by pressing the On/Off button (hold down for 2 seconds).
2.
Close the door by pressing it in until it clicks closed. The buttons are only enabled when the door is
closed.
3.
Select the required program with the selection buttons.
4.
You can now view the nominal program duration by pressing the ON/OFF button.
5.
Press the Start/Pause button to start the cycle
6.
The start of the cycle is confirmed by two beeps.
7.
Once the program has terminated, the display reads “End” alternating with the code of the program just
run.
NOTE - DISPLAY CONTENTS WITH CYCLE RUNNING
While the cycle is running, the following appear on the display 5 second intervals, in this order:
- Code of current program, e.g. P3
- Time remaining e.g.: 26
- Tank temperature e.g.: 55°C
Only for models with dryer:
During the drying phase the displayed temperature is that of the air entering the tank; this
temperature is only in the air duct and not uniform in the tank
NOTE – PROGRAM RUN TIMES
The run times displayed on the control panel are approximate; the temperature and pressure of
the water supply, as well as the tableware load, will affect the actual duration
The times provided refer to the machine operating with a 400 V three-phase electricity supply
and 55°C hot water supply, with no load.
If the peristaltic kit is installed, the cycle time is extended by at least one minute.
This does not include the times of the initial resin washing phases
If necessary, a resin regeneration cycle is run at the end of each program and a resin wash at the
start of the next, to ensure that the softener system works properly.
If the Repeat function is selected, these cycles do not run automatically, but must be selected by
the operator when the warning message displays on the control panel (R).
The resin regeneration and wash procedures are not included in the theoretical cycle time shown
initially on the display.
If the Repeat function is enabled, leave the door ajar after unloading the dishes if the appliance is
not to be reused immediately; if it will not be used for some time, perform a drain cycle before
reusing it to prevent foaming.
