25
5.9
Drying cycle (where applicable)
The drying cycle runs at the end of the wash program, see table of programs.
If the current program includes drying, the corresponding indicator LED turns on.
5.10
Repeat (where applicable)
The Repeat function speeds up operation by reusing the last rinse water for the next wash.
5.11
End of cycle
Once the program has terminated, the display reads “End” alternating with the program code.
“End” is only displayed if all steps of the program have completed successfully; it is not displayed if the program
has been paused, if a malfunction has compromised the result of the wash, or if the auto open option is enabled.
The end of the cycle is confirmed by a beep sounding.
If auto open is enabled, the door opens automatically and 4 horizontal dashes are displayed. Auto
open is not activated if alarms occur during the program or if Repeat is enabled. The corresponding
indicator LED turns on to confirm that the option has been enabled.
If the dry option has been enabled, the drying indicator LED turns on: For programs which include
this option, the LED is:
1. Lit steadily when a program is running or has terminated successfully
2. Flashing if drying is interrupted, during cooling, or at end of cycle due to a power failure or forced
interruption
Performing resin regeneration.
When the “R” symbol is lit, it is recommended a complete drain cycle is performed as soon as possible; the
machine will then regenerate the resin automatically .
NOTE – PROGRAM RUN TIMES
The run times displayed on the control panel are approximate; the temperature and pressure of
the water supply, among other factors, will affect the actual duration.
If necessary, a resin regeneration cycle is run at the end of each program and a resin wash at the
start of the next, to ensure that the softener system works properly. If the Repeat function is
selected, these cycles do not run automatically, but must be selected by the operator when the
warning message displays on the control panel (R).
These cycles are not included in the nominal run time display.
