Smeg SHW800B, Instruction Manual

Page: 6 / 16

EN
6
6
INSTALLATION
Wall drilling and bracket fixing
11a
1
1
11
12a
11
12a
3
292 292
960
X
1÷2
7.2.1
368
743
As a first step, proceed with the following drawings:
• a vertical line up to the ceiling or up to the upper limit, at the centre of the area in which the
hood is to be fitted;
• a horizontal line at a minimum 960 mm above the cooker top.
• Mark a point
(1) on the horizontal line, 292 mm to the right of the vertical reference line.
• Repeat this operation on the other side, checking that the two marks are levelled.
• Mark a reference point
(3) at 743 mm above the cooker top on the vertical reference line.
• Drill at the marked points (1) , using a ø 12 mm drill bit.
• Drill at the marked point (3) , using a ø 8 mm drill bit.
• Insert the bracket plugs 11a into the holes ( 1) and tighten the screws.
• Insert plug 11 into hole (3) .
• Place bracket 7.2.1 on the wall, about 1-2 mm from the ceiling or from the upper limit,
aligning the centre (notch) with the vertical reference line.
• Mark the wall at the centres of the bracket holes.
• Place the bracket
7.2.1 on the wall at X mm below the first bracket (X = height of the upper
chimney section), aligning the centre (notch) with the vertical line.
• Mark the wall at the centres of the bracket holes.
• Drill ø 8 mm holes at all the marked centre points.
• Insert the wall plugs
11 in the holes.
• Fix the brackets using the 12a screws (4,2 x 44,4) supplied with the hood.