Installation
33
EN
Connection with a rubber hose
Verify that all following conditions are met:
• Flexible hose must comply with AS/NZS
1869 Class B or D, be of appropriate
internal diameter for the total gas
consumption, be kept as short as
possible (not exceeding 1200mm), must
not be in contact with the floor or any hot
or sharp surfaces.
• The hose assembly must not be subject to
strain, abrasion, kinking or deformations.
• Only use a licensed gasfitter to install this
barbecue and other trades as
applicable; electrician, carpenter,
bricklayer.
• The hose is fixed to the hose connection
with safety clamps;
• Installation with rubber hose must be
carried out so that the length of the
piping does not exceed 1.5 metres.
• No part of the hose is in contact with hot
walls (max. 50 °C);
• The hose is not under traction or tension
and has no kinks or twists;
• The hose is not in contact with sharp
objects or sharp corners;
• If the hose is not perfectly airtight and
leaks gas, do not try to repair it; replace
it with a new hose.
5.3 Adapting to different types of gas
In case of operation with other types of gas,
the burner nozzles must be changed and
the minimum flame adjusted on the gas
taps.
Replacing nozzles
1. Remove the grills and griddle, diffusers
and then the components (see
“Diffusers”).
2. Remove the burners (see “Removing the
3. Replace the nozzles using a 7 mm socket
wrench according to the gas to use (see
“If the gas leak persists, contact the
nearest supplier.”).
4. Reposition the burners in their correct
seats.
