E n g l i s h
|
4
appliance indicated on t he information plate). The product must be positioned so that the plug is always
accessible.
The appliance comes with certified cable and plug therefore they must not be tampered with or modified.
Only the cable can be substituted:
this must be carried out by a q ualified authorized technician.
The
earth wire must always be yellow green.
APPLIANCE NOT SUPPLIED WITH CABLE WITH THREE PHASE TERMINALS
Articles supplied by us come with t erminals such as
in the imag e. To conne ct to the mains see the label
in the manual and stuck to the lower part of the back
of the appliance near the Information plate.
The device must be connected to th e electricity with
a rubber cable such as H07RN-F.
WARNING: the yellow/green voltage w ires in the
earth cable must be 3cm longer than the others.
The device must be connected directly to the mains and must have an easily accessible switch from the start,
installed for the device according to the national, internat ional and local laws in the country where it is
installed. This switch must separate polarization guaranteeing complete disconnection in accordance with the
overvoltage III category.
Correct earthing is obligatory and the earth wire must not be operated by the protection switch.
CABLE CONNECTION
Proceed as follows to co nnect the power supply wire to the
terminal board:
•
( A1 ) Loosen the tops of the cable gland and open
the bottom part of th
e back of the appliance by
loosening the screws.
•
( A2 ) Feed the new cable through the cable gland.
Connect the cable voltage to the terminal
strips
following the connectio n diagram o n the label on the
back of the appliance. Only connect what is indicated
inserting th e copper bridge and the electricity cable
together under the screws, in the tightening direction,
so the cab le and the bridge are tightly fixed by
tightening t he screw. T he type of cable to be used
(HO7RN-F) is indicat ed on the label for each
connection and the voltage sections in mm².
•
( A4 ) Clo se the bott om part of the back of the
appliance b y tightening the screws and fit the cable
by tightening the cable gland top.
