Smeg KV194, Instruction Booklet

Page: 25 / 39

Instructions for use
25
Light brightness adjustment
_______________________________________________________
Briefly touching the button immediately switches the lights on or
off. Touching and holding this button for more than 1 second gradually
increases the brightness to the maximum level and then decreases it to
the minimum level as long as the button is pressed. Release the button
once you have obtained the required brightness. This level of
brightness will be saved in the non-volatile memory so that it will be
set each time the light is switched on by tapping the button once.
Tapping the light button twice when the light is off will set it to
maximum brightness. It is factory set to maximum brightness.
Filter alarm reset
_______________________________________________________
After 100 hours of hood operation, buttons , , , will start
to flash to remind you to clean the filters. To reset this warning, press
the On/Off button for 5 seconds, the light of the On/Off button will
flash once to indicate that the filter time has been reset.
24h air exchange function
_______________________________________________________
The 24h air exchange function allows you to clean the air in the
room. To start the 24 hour function, press and hold the
button
for 3 seconds. The extraction hood will run at minimum speed for 10
minutes every hour (up to a maximum of 24 hours). The and
buttons will flash as long as the function is active. Briefly touching
any button (apart from the
button) will disable the function.
EN