5
4 INSTALLATION
INSTRUCTIONS
FOR THE AFTER-SALES SERVICE
4.1 Water connection
Water supply and drain connection:
The water pipelines and electricity supply cable lead out of the bottom right-hand
corner of the appliance. Connect the water intake hose to a connector with
¾” gas
threaded fitting, fitting the filter
A
provided (in models with aquastop, the filter and ring-
nut form a single unit).
The connection to the water mains must only be made with new hoses; the use of old
or worn hoses is not permitted.
The dynamic
intake pressure
must be between
1 and 6 bar
; if it is higher, installation of a pressure reducer is
recommended.
It is essential to fit a main stop tap on the water intake pipeline; the tap must be accessible after installation of
the appliance, so do not install it behind the dishwasher.
The stated cycle duration refers to appliances supplied with
hot water at 50°C
.
If the appliance is supplied with cold water, the cycle duration might increase depending on the intake water
temperature, since the dishwasher is fitted with the HTR system, which requires set temperature and pressure
for rinsing.
Drainage:
The dishwasher
is fitted with a drain pump
and can operate with drain
connections on the floor or wall.
Caution:
make sure that the intake and drain hoses are not bent,
constricted or crushed after installation.
If the drain connection is to an
outlet with valve, the maximum height of the drain is reduced to 600 mm
.
In all cases, after installation check that the drain is fully functional by pumping out the tank completely (P0
cycle).
Summary of Contents for CW500
Page 1: ...PROFESSIONAL DISHWASHER ...
