19
TOTAL PUMP-OUT AT THE END OF THE DAY + Resin regeneration
(form models with water softener)
From time to time, on models with water softener, before the total pump-out at the end of the day the user will
automatically be reminded to carry out the resin regeneration cycle, required after a number of washes which
depends on the hardness of the water (about 30 for average setting H03). In this case the sequence will be as
follows:
Press the pump-out button ;
“rEgE”
and the
duration appear on the display.
Confirm by pressing
; light
L2
turns orange
.
At the end of the pump-out, the appliance sets in
“
OFF
” status.
Topping up with regenerating salt (for models with water softener)
Salt must be added when the “no salt” light (
) appears on the display.
Top up with salt
when there is no water in the tank
to prevent washing water from getting into the water softener
device.
Caution:
use only salt of the specific type, do not use cooking salt.
The salt tank has a capacity of about
1 kg of coarse-grained salt.
The salt reservoir is in the bottom of the tank. After removing the basket, undo the cap and pour the salt in using
the funnel supplied. Remove any salt residues around the opening before screwing the cap back on.
11 MAINTENANCE AND CLEANING
Although no particular scheduled maintenance is required, users are advised to have the dishwasher checked by a
specialist technician twice a year.
N.B.:
the manufacturer accepts no liability for wilful damage or damage deriving from carelessness, neglect, failure
to comply with instructions, regulations and standards or incorrect connections.
11.1 Daily cleaning
The dishwasher has
IPX4
protection, but the use of direct water jets for cleaning is
forbidden.
Cleaning the filter during the day
In case of particularly heavy-duty working conditions, the filter should be cleaned every 30-40 cycles, keeping the
machine in operating conditions; to do this, carry out the “partial tank pump-out” routine (program “P0”).
Press the button, and hold it down, until
“P0”
and
the duration of
1’
appear on the display.
Confirm by pressing
; light
L2
turns orange
.
At the end of the pump-out the word
“End”
flashes on
the display. The display returns to showing
“P1”
. Close
the door again to start filling the tank prior to
performance of a new wash cycle.
Summary of Contents for CW500
Page 1: ...PROFESSIONAL DISHWASHER ...
