QuickServer Start-Up Guide
Page 14 of 60
4.3.1.3 Power Jumper Settings
The QuickServer Carrier Board power jumper is set to position A by default, but can be changed to
position B for other power supply requirements.
Position A:
The Carrier makes use of a full-wave rectifying bridge. Can be used for 12-24VAC input or
9
– 30VDC input. At 9VDC this becomes marginal.
Position B:
The Carrier makes use of a half-wave rectifying bridge. Best position for grounded AC
transformers and for using DC voltage down to 9VDC.
Power Jumper Switch
in position “A”
Figure 7: Power Jumper Switch
