SMC Networks SMCGS10P-Smart, Installation Manual

Page: 53 / 68

C
HAPTER
4
| Making Network Connections
Twisted-Pair Devices
– 51 –
2.
If the device is a network card and the switch is in the wiring closet, attach
the other end of the cable segment to a modular wall outlet that is
connected to the wiring closet. (See the section “
"Network Wiring
Connections" on page 51 .”) Otherwise, attach the other end to an available
port on the switch.
Make sure each twisted pair cable does not exceed 100 meters (328 ft) in
length.
3.
As each connection is made, the Link LED (on the switch) corresponding to
each port will light green or amber to indicate that the connection is valid.
N
ETWORK
W
IRING
C
ONNECTIONS
Today, the punch-down block is an integral part of many of the newer equipment
racks. It is actually part of the patch panel. Instructions for making connections
in the wiring closet with this type of equipment follows.
1.
Attach one end of a patch cable to an available port on the switch, and the
other end to the patch panel.
2.
If not already in place, attach one end of a cable segment to the back of the
patch panel where the punch-down block is located, and the other end to a
modular wall outlet.
3.
Label the cables to simplify future troubleshooting. See "Cable Labeling and
Connection Records" on page 57 .