-12-
No.SFOD-OML0002-A
○
Peak/Bottom hold value
When the
is pressed with the power supply on, the indication will be changed to instantaneous value,
peak hold value, bottom hold value and instantaneous value, in that order.
∗
: Release the
after "P" or "b" is displayed so as not to turn off the power supply.
•
Peak hold value
The maximum charged potential and "P" are displayed.
The maximum charged potential is continuously detected and updated from when the peak hold is started.
If the value over the held maximum charged potential is detected, the display will change.
•
Bottom hold value
The minimum charged potential and "b" are displayed.
The minimum charged potential is continuously detected and updated from when the bottom hold is
started. If the value under the held minimum charged potential is detected, the display will change.
○
Zero clear
A displayed value can be adjusted to zero at measured charged potential in a range of
±
5%F.S. of default
potential.
(There will be a slight displacement, depending on the deviation of the sensor itself and ambient
environment of the sensor when the zero clear is performed.)
When the
and
are pressed for 6 s. or more with the power supply on, the displayed value is reset
to zero, and then the measuring mode is recovered automatically.
Once the power supply is turned off, the offset value for zero clear is cleared.
○
Light-up of back light
When the
is pressed while the charged potential is displayed, the back light will turn on.
Re-pressing the
will turn off the back light.
