-5-
No.SFOD-OML0002-A
■
NOTE
○
Follow the instructions given below when designing, selecting and handling the product.
●
The instructions on design and selection (installation, wiring, environment, adjustment,
operation, maintenance, etc.) described below must also be followed.
∗
Environment
•
Avoid using in a place where noise (electromagnetic wave and surge) is generated.
This can result in malfunction (display of incorrect value), deterioration and damage of internal elements.
•
Do not leave the product in a place exposed to direct sunlight, inside a closed car and/or near a heating
appliance.
High temperature can cause deformation, discoloration and damage of the product.
•
Do not use in a place where the product could be splashed by oil or chemicals.
This can cause failure.
∗
Handling
•
Do not carry or swing the product by the sensor cable.
Damage can result.
If the cable gets caught on equipment, injury or damage to property can be caused.
•
Do not press the setting buttons with sharp pointed objects.
The setting buttons can break.
•
Do not touch the detection port of the sensor with a finger or metal object directly.
Directly touching the detection port of the sensor can cause a loss of specified function and performance, and
failure.
•
When measuring objects with a high charged potential, consider a risk of electrostatic discharge to user.
Use a high voltage measuring handle available as an option and wear protective rubber gloves.
•
Gradually bring the sensor closer to the measured target from a distance, and stop the measurement
immediately if the displayed value indicates overflow (HHH) or underflow (LLL).
The sensor is charged to high potential and can discharge to user.
•
Do not place objects and cables other than the measured target near the detection port of the sensor.
Otherwise, their charged potential can cause the displayed value to deviate from the actually measured value.
•
The measurement distance is 50 mm.
Refer to scales shown on the label attached to the product.
•
The product is designed to measure static electricity, and must not be used for other purposes.
The product may show unexpected behavior and can fail to operate normally.
∗
Maintenance
•
Use two off AA alkali dry cell batteries (LR6) in the product. Other batteries are not suitable.
Use of incorrect batteries can result in damage.
•
Pay attention to the po) and negative(-) polarities of the battery as stamped on the body of the
product.
If they are placed the wrong way around, the battery may leak or even burst.
•
Do not mix up a new battery and old battery or other kinds of battery.
This can result in battery leakage, which causes failure.
•
Remove the batteries when the product will not be used for extended periods.
Leaving batteries in the product can result in battery leakage, which causes failure.
•
If the body gets stained, clean it by wiping off with a soft cloth.
If the stain is persistent, use a cloth immersed in a dilute solution of neutral detergent and wrung tightly and then
clean up with a dry cloth.
