SMC Networks Electro Industries ProtoCessor, Startup Manual

Page: 3 / 32

Electro Industries ProtoCessor Start-up Guide
Page 3 of 32
Quick Start Guide
1. Record the information about the unit. (
Section 3.1
)
2. Configure COM settings for the device to connect to the ProtoCessor. ( Section 3.3 )
3. Connect the ProtoCessor 2 pin LonWorks port to the field protocol cabling. ( Section
4.3
)
4. Connect a PC to the ProtoCessor via Ethernet cable. ( Section
5.1
)
5. Ethernet Network: Use a browser to access the ProtoCessor FS-GUI to change the IP Address. No
changes to the configuration are necessary. ( Section 5.3 )
6. The ProtoCessor must be commissioned on the LonWorks network. This must be done by a LonWorks
administrator using a LonWorks commissioning tool. ( Section 6 )
07/10/2019 BI806