Electro Industries ProtoCessor Start-up Guide
Page 15 of 32
6 COMMISSIONING PROTOCESSOR ON A LONWORKS NETWORK
Commissioning may only be performed by the LonWorks administrator.
6.1 Commissioning ProtoCessor FPC-ED4 on a LonWorks Network
During the commissioning process, the LonWorks administrator may prompt the user to hit the service pin
on the ProtoCessor FPC-ED4 at a specific point (this step occurs at different points of the commissioning
process for each LonWorks network management tool).
•
If an XIF file is required, see steps in
Section
6.1.1 Instructions to Upload XIF File from ProtoCessor Using Browser
•
Connect a Cat-5 Ethernet cable (straight through or cross-over) between the PC and ProtoCessor.
•
The default IP Address for the ProtoCessor is
192.168.1.24
, Subnet Mask is
255.255.255.0
. If the
PC and ProtoCessor are on different IP networks, assign a static IP Address to the PC on the
192.168.1.xxx network.
For Windows 10:
•
Find the search field in the local computer’s taskbar (usually to the right of the windows icon )
and type in “Control Panel”.
•
Click “Control Panel”, click “Network and Internet” and then click “Network and Sharing Center”.
•
Click “Change adapter settings” on the left side of the window.
•
Right-click on “Local Area Connection” and select “Properties” from the dropdown menu.
•
Highlight
and then click the Properties button.
•
Select and enter a static IP Address on the same subnet. For example:
•
Click the Okay button to close the Internet Protocol window and the Close button to close the
Ethernet Properties window.
Figure 11: LonWorks Service Pin Location
07/10/2019 BI806
