Electro Industries ProtoCessor Start-up Guide
Page 30 of 32
READ/WRITE:
RT Offset (±°F, Default = 0)
OT Offset (±°F, Default = 0)
ST Offset (±°F, Default = 0)
Base Temp. High Mass (70-110°F, Default = 90°F)
Base Temp. Low Mass (120-140°F, Default = 120°F)
Set Point (40-195°F, Default = 155°F)
OT at 0 Degrees Set Point (40-195°F, Default = 155°F)
Maximum Stages (4-15, Default = 15)
Differential:
1) 10°F (Default)
2) 15°F
3) 20°F
Troubleshooting Stage Code (0-15, Default = 0)
0 -> 10VDC (YES/NO, Default = NO)
Stage Sequence Minutes (0-99 minutes, Default = 1)
Boiler Type:
1) Single (Default)
2) Lead
3) Lag
Lag Boiler Delay (0-999 minutes, Default = 15)
Force Troubleshooting (YES/NO, Default = NO)
Reset Fault Counts (YES/NO)
Micro Reset (YES/NO)
Factory Reset (YES/NO)
Must reset (cycle power) if any of the following are changed:
1) Troubleshooting enabled or disabled (Force Stages YES/NO)
2) 0 -> 10VDC enabled or disabled (YES/NO)
3) OT sensor removed or added
4) Dsply/BACnet switch (SW4) changed
5) Boiler type changed (Single, Lead or Lag)
07/10/2019 BI806
