6. Check the actual actuation status and adjust the auto switch mounting position.
According to the installation environment, the rotary table may not operate even at its proper mounting
position. Even when setting at a midpoint of the stroke, check the actuation status and make the
adjustment in the same manner.
7. Be very careful when handling the auto switch mounting band, as it has a thin structure.
Wiring
1. Confirm proper insulation of wiring.
If there is any improper insulation (mixed contact with other circuit, grounding fault, or improper
insulation between terminals, etc.) in the wiring, an over-current flows in, causing the auto switch to
break.
2. Wire separately from power lines of high voltage lines, avoiding parallel wiring of wiring in
the same conduit with these lines.
If an inrush current is generated, the noise may cause the auto switch to malfunction.
3. Be certain to connect the load before power is applied.
<2-wire type>
If the power is turned ON when an auto switch is not connected to a load, the auto switch will be
instantly damaged because of excess current (short circuit).
It is the same as when the 2-wire brown lead wire (+, output) is directly connected to the (+) power
supply terminal.
4. Carry out the wiring work after shutting down the power.
If the wiring work is performed with the power turned ON, this may cause electric shock, malfunction, or
damage to the auto switch.
5. Avoid repeatedly bending or stretching lead wires.
Broken lead wires will result from repeatedly applying bending stress or stretching force to the read
wires.
Stress and tensile force applied to the connection between the lead wire and auto switch increases the
possibility of disconnection.
6. Do not allow short-circuit of loads.
<Reed>
If the power is turned ON with a load in a short circuit condition, the switch will be instantly damaged
because of excess current flow into the switch.
<Solid state>
PNP output type auto switches do not have built-in short circuit protection circuits.
Carefully handle as the auto switch may be damage.
-13-
Warning
2020-10-13 10:36
DI987004
