Command Line Interface
4-170
4
map ip port
(Interface Configuration)
This command sets IP port priority (i.e., TCP/UDP port priority). Use the
no
form to
remove a specific setting.
Syntax
map ip port
port number
cos
cos-value
no map ip port
port-number
•
port-number -
16-bit TCP/UDP port number.(Range 1-65535)
•
cos-value -
Class-of-Service value. (Range: 0-7)
Default Setting
None
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP DSCP,
and default switchport priority.
• This command sets the IP port priority for all interfaces.
Example
The following example shows how to map HTTP traffic to CoS value 0:
map ip precedence
(Global Configuration)
This command enables IP precedence mapping (i.e., IP Type of Service). Use the
no
form to disable IP precedence mapping.
Syntax
[
no
]
map ip precedence
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• The precedence for priority mapping is IP Port, IP Precedence or IP DSCP,
and default switchport priority.
• IP Precedence and IP DSCP cannot both be enabled. Enabling one of these
priority types will automatically disable the other type.
Console(config)#interface ethernet 1/5
Console(config-if)#map ip port 80 cos 0
Console(config-if)#
Summary of Contents for 100BASE-TX
