HEM4000 Engine Controller User Manual Page 22 of 46
No.
Item
Range
Default
Description
(If diesel driven suction pump enabled,
it is also can be the cranking time).
6
Cranking Rest Time
(3-60)s
10
The waiting time before the second
powering up when engine starting fails
(If diesel driven suction pump enabled,
it is also can be cranking rest time of
diesel driven suction pump).
7
Safety On Delay
(0-3600)s
10
Alarms for low oil pressure, high
temperature, under speed, under
frequency/voltage, charging failure are
inactive during this time.
8
Start Idle Time
(0-3600)s
0
Idle running time of engine when
starting.
9
High-speed Warming
Up Time
(0-3600)s
10
Warming-up time for engine after high
speed running and before loading.
10
High-speed
Cooling
Time
(0-3600)s
10
Heat dissipating time before engine
stop.
11
Stop Idle Time
(0-3600)s
0
Idle running time when engine stop.
12
ETS Output Time
(0-3600)s
20
The time of powering up the ETS
before stopping (If diesel driven
suction pump enabled, it is also can be
stop output time of diesel driven
suction pump).
13
Waiting Stop Time
(0-3600)s
0
Time between ending of idle delay and
stopping completely when ETS Output
Time is 0;
Time between ending of ETS delay and
stopping completely when ETS Output
Time is not 0.
14
After Stop Time
(0-3600)s
0
Time between engine stop and standby
status.
15
Fuel Pre-supply Rest
Time
(0-12)h
2
Interval between the completion of the
current pre-fuel supply output and the
next pre-supply output in standby
status when output is configured as
“Fuel Pre-supply”; If time is 0, fuel
pre-supply is not outputted in standby
status.
16
Fuel Pre-supply Time
(3-30)s
5
Fuel pre-supply output time when
output
is
configured
as
“Fuel
Pre-supply”.
Engine Setting
1
Speed Signal Source
(0-1)
0
0: Speed Sensor; 1: W/L
2
W/L Ratio
(0-99.99)
9.04
3
Flywheel Teeth
(1.0-300.0)
118.0
Tooth number of the engine, which is
