HAT163 ATS CONTROLLER USER MANUAL
HAT163 ATS Controller 2018-05-20 Version 1.0 Page 13 of 21
8. PARAMETERS SETTING
8.1 PARAMETERS SETTING MODE
In manual mode, enter into parameters setting mode by pressing
for 8s and manual/auto
indicator
and gen status indicator flash;
①
,
②
,
③
,
④
indicators illuminate. LED numbers please to
see the following picture.
Fig.3
– Parameter Configuration
NOTE: At this moment, press
will be back to normal mode after LED flash.
8.2 PARAMETERS SETTING
When it entered into parameter setting mode, users can adjust parameters by pressing
. And
④
and
⑦
LEDs are illuminated.
①
,
②
,
③
,
④
indicators mean setting items numbers (currently item
number is 1);
⑤
,
⑥
,
⑦
indicators mean these parameter values (currently parameter value is 1).
Configurable parameter list please check
―Table 6 – Parameters Definition and Range Table (1)‖ of item
7.
Specific settings are as below:
1) Select setting number which needs to adjust by pressing
and
;
2) Enter into setting status by pressing
and
⑦
indicator flashes;
3) After set this parameter by pressing
and
, and press the key to save the value.
4) Hold and press
after all parameters are configured, and release
when all LEDs flash,
which means parameters are all saved and then will return to normal mode.
NOTE
: See “Table 8 Parameter Value Comparison” for the values corresponding of LED indicators.
NOTE: after parameters configured completely, users need to press
to back to the normal mode to save
the parameters. Otherwise, the setting parameters will be lost after controller power outage.
