24
Tariff pulse when call starts/ends
Signaling of call start or end by tariff pulse.
Setting options:
None
-SmartGate doesn't send tariff pulse as signaling of call
start/end.
Call end
-SmartGate sends tariff pulse when call ends.
Call start
-SmartGate sends tariff pulse when call starts.
Call start and end -SmartGate sends tariff pulse when call starts and
ends too.
Default setting: None
Tariff pulse frequency
[kHz]
Tariff pulse frequency setting.
Setting options:
16 kHz
-SmartGate transmits 16 kHz tariff pulses
12 kHz
-SmartGate transmits 12 kHz tariff pulses
Default setting: 16 kHz
Ringing signal – frequency
[Hz]
Ringing signal frequency setting.
Setting options:
25 / 50 Hz
-SmartGate rings with 50 or 25 Hz on FXS interface
Default setting: 50 Hz
Ringing signal - cadence
Ringing signal cadency setting.
Setting options:
1000/4000 ms
- 1 s ring, 4 s pause
400/200/400/2000 ms
- 400ms ring, 200ms pause, 400ms ring, 2s pause
1500/3500 ms
- 1,5 s ring, 3,5 s pause
2000/4000 ms
- 2 s ring, 4 s pause
Default setting: 1000/4000 ms
CLI transmitting
Set this item to enable/disable identification of a telephone line calling from a
GSM network. The function can be enabled if you have a device on your
telephone line that is capable of receiving FSK according to ETSI standards.
Setting options:
Disable
-SmartGate does not transmit the CLI.
FSK during ringing -SmartGate transmits the FSK-based CLI according to
the ETSI EN 300 659 standard (transmission during ringing).
Default setting: Disable
Replace cha in CLI by
If this parameter is filled, the + character in the international prefix of CLI is
replaced by the defined string. The + character can neither be transmitted by the
FSK protocol nor dialed by the DTMF from a terminal.
Setting options: 0-4 characters (0-9,*,#)
Default setting: blank
Summary of Contents for 2N
Page 1: ......
