Longo programmable controller LPC-2.DO4
Mounting instructions:
1. Switch OFF main power supply.
2. Mount LPC-2.DO4 module to the provided place inside an electrical panel (DIN EN50022-35
rail mounting).
3. Mount other LPC-2 modules
(if required). Mount each module to the DIN rail first, then
attach modules together through K1 and K2 connectors.
4. Connect digital output wires according to the connection scheme in Figure 2.
5. Switch ON main power supply.
Dismount in reverse order. For mounting/dismounting modules to/from DIN rail a free space of at
least one module must be left on the DIN rail.
NOTE: LPC-2 main module should be powered separately from other electrical appliance connected
to LPC-2 system. Signal wires must be installed separately from power and high voltage wires in
accordance with general industry electrical installation standard.
Figure 4: Minimum clearances
The clearances above must be considered before module mounting.
6
60 mm
or more
60 mm
or more
60 mm
or more
60 mm
or more
