19
DBG>?
===========================================================================
Command Line Interface Help:
d
Enable/Disable debug d [on][off]
sw
Switch Port
sw [output] 1-16 [input] 1-16
br
Broadcast Port
br [input] 1-16
om
Set output mode
om [output] [mode# (0-2) | ?]
o
Enable/Disable Output o [output] [0 = disable | 1 = enable
q
Query Crosspoints
h Toggle Hotplug h [input]
reset Restore Factory Settings
boot
Reboot matrix
info
Display matrix info
edid
Manage EDID
help
Command list
?
===========================================================================
DBG>sw 2 2
Switched Output 2 to Input 2
DBG>om 1 0
HDCP is now in mode 0 on output 1.
DBG>br 2
EDID>learn
Successfully learned EDID!
EDID>learn
Successfully learned EDID!
EDID>learn
Successfully learned EDID!
DBG>edid
EDID Mode:
EDID>
To display the help menu for a list of commands, type “? <enter>”
To switch ports, type “sw [output] 1-16[input] 1-16 <enter>”
To set the output mode, type “om [output] [mode# (0-2) | ?] <enter>”
To set the broadcast port, type “br [input] 1-8<enter>”
To manage the EDID modes, type “edid <enter>” and you will see the following prompt:
To learn the EDID, type “learn <enter>”
To set the EDID to factory defaults, type “savi <enter>”
To exit the EDID prompt, type “exit <enter>”
Using RS-232 Control (continued)
