18
When you connect to the HDR8X8/HDR16X16 to a computer via an RS-232 connection,
you will see the following screen (results from HDR16X16 shown):
There are two primary modes of operation for the HDR8X8/HDR16X16: Command Mode
and Debug Mode. When connecting to the HDR8X8/HDR16X16 via RS-232, it will start in
Command Mode (see Command Mode p. 19 for options). Debug Mode is a more user-
friendly way of operating the HDR8X8/HDR16X16 and includes instructional menus. The
following section details the use of the Debug Mode.
To enter Debug Mode type “d on <enter>” and you will see the following prompt:
To exit Debug Mode (and enter Command Mode) type “d off <enter>”
To display the HDR8X8/HDR16X16 information including crosspoint data, type “info
<enter>”
SmartAVI HDMI 16X16 ver 12.06.11#1
d on
Debug mode:
DBG>
DBG>d off
Command line debugging disabled.
Type “d on” to re-enable.
DBG>info
===============================================================
SmartAVI
HDMI 16X16
fw ver. 12.06.11#1
Frame Address: 0
OUT IN IN STATE OUT_ENABLED
===============================================================
1 1 HDMI* YES
2 1 HDMI* YES
3 1 HDMI* YES
4 1 HDMI* YES
5 1 HDMI* YES
6 1 HDMI* YES
7 1 HDMI* YES
8 1 HDMI* YES
...
16 1 HDMI*
YES
Note: an asterisk (*) denotes that the signal is HDCP encrypted.
Using RS-232 Control (continued)
