Manual code search
smart sliderX
13
2. Press and release the Mode key (4) of the device you want to control (TV, DVD or AMP).
The red LED indicator (1) blinks once. Make sure your Universal Remote Control is not in
STB Mode.
3. Press and hold the Mute (2) and Power (3) keys together until the LED indicator (1) blinks
and remains on. Release the Mute and Power keys.
4. Using the numeric keypad (5), enter the 4 digit code from the Code Book. The LED (1) turns
off after the last digit is entered. If you entered a wrong code the LED (1) blinks for 3 se-
conds and then goes off. You have to repeat from step 2.
5. Point the remote in the direction of your device and press the Power button (3). Your device
should turn off. Check other functions (for example for a DVD:
►
(Play) or
►►
(Fast For-
ward), etc…). If certain functions are not responding this indicates that the entered code is
not the correct one. In that case repeat the above procedure with the next corresponding
code of your brand.
6. Repeat this procedure from step 1 for the other equipment you want to control (TV, DVD,
AMP)
6 Manual code search
If your equipment (TV, DVD, etc....) does not respond, try the other codes for your brand. If it still
doesn’t respond, try the Code Search method.
Note:
as you can dedicate any appliance (TV, DVD, SAT...) to the DVD and AMP modes, you
need first to enter any 4 digit code for the kind of appliance you wish to control (found in the
code book), i. e.: If you want to program a SAT under the DVD key, enter any SAT code found in
the code book and then follow the steps below:
1. Make sure your equipment is switched on.
2. Press and release the Mode key (4) of the device you want to control (TV, DVD or AMP).
The red LED indicator (1) blinks once. Make sure your Universal Remote Control is not in
STB Mode.
3. Press and hold the Mute (2) and Power (3) keys together until the LED indicator (1) blinks
and remains on. Release the Mute and Power keys.
4. Point the remote control at the device you wish to control and press P+ (17) repeatedly until
the channel changes. If you step pass the correct code use P- (17) to go back to the right
code. Each time you press the P+ (or P-), the red LED indicator will blink.
5. When the equipment you want to control reacts press OK (13) to confirm the code. That’s all.
Notes:
If your equipment doesn't have P+, you can use the Power (3) or
►
Play (21) key.
If all codes have been searched, the LED indicator will blink for about 3 seconds.
If certain functions of your equipment can’t be controlled you have to find a different code for
your brand.
7 Programming a Combo (combined device such as TV/VCR, TV/DVD...)
Depending on the brand and the kind of COMBO (TV/VCR, VCR/DVD, etc.), you will be required
to enter a single code for both devices in the COMBO, or to enter two codes, one code per
device. Consult the code list.
Before you start programming, you must find the code of the device to be controlled, refer to the
code list supplied with this user manual.
