SMART Podium ID422w, Installation And User Manual

Page: 22 / 63

12 | CHAPTER 2 – INSTALLING THE SMART INTERACTIVE PEN DISPLAY
99-00724-00 REV C0
To connect a projector
or monitor to the
interactive pen display
1. Connect a VGA (RGB) video cable (not supplied) to the RGB Video OUT
receptacle on the interactive pen display.
2. Connect the other end of the cable to the Video Input receptacle on your
projector or monitor.
3. For details about the projector’s connectors, see the instructions that came with
your projector.
Attaching the Pen
Use the tether to attach the pen to the interactive pen display, so the pen is always
within reach.
NOTE
When you’re not using the pen, put it in the storage compartment that’s located on
the top of the unit.
To attach the tether
to the pen and a
SMART Podium ID422w
1. There is a loop in the cord at each end of the tether. Thread one loop through the
opening at the end of the pen, and then slip the rest of the cord through the loop.
Carefully pull the cord until the loop is snug.
2. Thread the other loop through the installation fitting. Then slip the pen and the rest
of the tether through the loop. Carefully pull the pen until the loop is snug.
3. Attach the installation fitting to the back of the interactive pen display using a
screwdriver or a small coin.
Installation
Fitting
Tethe
Pen