SMART BOARD 8055i-G5, Administrator'S Manual

Page: 6 / 84

IMPORTANT INFORMATION
iv smarttech.com/kb/171000
l
The accessory slot’s maximum available power is 60 W. The slot is not a limited power
source. To reduce the risk of fire, make sure that accessories connecting to the slot satisfy
the fire enclosure requirements of IEC 60950-1.
l
You must connect the USB cable that came with the interactive flat panel to a computer that
has a USB compliant interface and that bears the USB logo. In addition, the USB source
computer must be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or
UL Mark(s) for CSA/UL 60950. This is for operating safety and to avoid damage to the
interactive flat panel.
IMPORTANT
l l
The following are the maximum power requirements for the interactive flat panel (including
the power requirements for the accessory slot):
Model Power requirements
SMART kapp iQ Pro™ 55 90V to 240V AC, 50 Hz to 60 Hz, 134 W
SMART kapp iQ Pro 65 100V to 240V AC, 50 Hz to 60 Hz, 199 W
SMART kapp iQ Pro 75 100V to 240V AC, 50 Hz to 60 Hz, 315 W
l
For additional requirements and other information, refer to the interactive flat panel’s
specifications (see Resources for decision makers on page 9).
Federal Communication Commission
interference statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
l
Reorient or relocate the receiving antenna.
l
Increase the separation between the equipment and receiver.
l
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
l
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the
user’s authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.