13
|
1012080 Rev A1
C H A P T E R 2
Installing your SMART Audio system
Installing the control unit
Install the mounting plate, and then attach the control unit and cable cover to the mounting
plate. Select a location on the wall that is within 8' (2.4 m) of a power outlet.
To install the mounting plate
1.
Hold the control unit mounting plate against the wall
where you plan to install it, and mark the screw holes
on the wall with a pencil. If you’re pulling cables
through the wall, trace the cabling hole
as well.
2.
Lower the control unit from the wall and drill holes at
the marks.
3.
Cut a cabling hole, if required.
4.
Screw the mounting plate to the wall with the
included screws and drywall anchors.
To attach the control unit to the mounting plate
1.
Attach the control unit to the mounting pegs on the
mounting plate.
2.
Slide the control unit down until it locks into place.
Cabling hole
Summary of Contents for Adio 340
