Chapter 2
Installing the display
smarttech.com/kb/171555
32
To turn on and set up the display for the first time
Important
Install the OPS
PC module before you turn the display on.
Notes
l
Touch is not available right after waking up the display or turning it on. Wait a few seconds and
then the display will respond to touch.
l
If a USB drive is connected to the display’s service port, do not remove the USB drive. The USB
drive contains an important firmware update.
1. Flick the switch beside the AC power inlet to the ON
(I) position.
o
SMART
Board MX (V2, V2-C, and V3) series
55" models
65" models
75" and 86" models
o
SMART
Board MX series
65" models
75" models
86" models
2. Press the
Power
button
on the front control panel or remote control
3. Select your preferred language, and then tap
Next
.
4. Select your country, and then tap
Next
.
5. Select your time zone, and then tap
Next
.
6. Set the date, and then tap
Next
.
7. Set the time, and then tap
Next
.
8. Name the display, and then tap
Next
.