SMART Embedded Computing Centellis 2x00 User Card-10GE, Installation And Use Manual

Page: 41 / 50

Centellis 2x00 User Card-10GE Installation and Use (6806800H33E) 41
Chapter 4
Board Exchange
4.1 Introduction
This chapter describes how to install the Centellis 2x00 User Card-10GE board and
includes the following information:

Before installation
 Installing the board in a shelf

Starting up the board
 Removing the board

Operation
4.2 Before Installation
This section provides the following information:

Requirements
 Unpacking and inspecting the board
4.2.1 Requirements
Before you power up the board, calculate the power needed according to your system
configuration.
4.2.1.1 Environmental Requirements
You must make sure that the board when operated in your particular system configuration
meets the environmental requirements specified below.
The system is shipped with pre-installed Centellis 2x00 User Card-10GE boards.
You have to observe the following procedures when ordering a board as a spare part
or exchanging a board.
Operating temperatures refer to the temperature of the air circulating around the
board and not to the component temperature.