Chapter 2
Installing the display
33
Connecting power and turning on the display for the
first time
The final step in installing and configuring the display is to connect power and turn it on. When you first turn
on the display, a setup wizard appears. Follow the steps in the wizard to complete the setup.
To connect the display to power
Connect the supplied
from the AC power inlet on the back of the display to a power outlet.
NOTES
o
Refer to the display’s specifications for power requirements and power consumption information
(see
o
The AC power output on the back of the display is rated at 250 W.
To turn on and set up the display for the first time
IMPORTANT
Install the OPS PC module before you turn the display on.
NOTE
If a USB drive is connected to the display’s service port, do not remove the USB drive. The USB drive
contains an important firmware update.
1. Flick the switch beside the AC power inlet to the ON (I) position.
2. Press the
Power
button
on the front control panel or remote control
