SMAR FRI303, Instruction Manual

Page: 26 / 36

FRI303 – Operation and Maintenance, Instruction Manual
3.8
Unit_Diag_Bit(87) = "Not used 87"
;
Unit_Diag_Bit(88) = "DI 1 Block: Out of Service"
Unit_Diag_Bit(89) = "DI 2 Block: Out of Service"
Unit_Diag_Bit(90) = "Not used 90"
Unit_Diag_Bit(91) = "Not used 91"
Unit_Diag_Bit(92) = "Not used 92"
Unit_Diag_Bit(93) = "Not used 93"
Unit_Diag_Bit(94) = "Not used 94"
Unit_Diag_Bit(95) = "Not used 95"
;
Unit_Diag_Bit(96) = "DO 1 Block: Out of Service"
Unit_Diag_Bit(97) = "DO 2 Block: Out of Service"
Unit_Diag_Bit(98) = "Not used 98"
Unit_Diag_Bit(99) = "Not used 99"
Unit_Diag_Bit(100) = "Not used 100"
Unit_Diag_Bit(101) = "Not used 101"
Unit_Diag_Bit(102) = "Not used 102"
Unit_Diag_Bit(103) = "Not used 103"
NOTE
If the FIX flag is active on LCD, the FRI303 is configured to "Profile Specific". When in "Manufacturer
Specific", the Identifier Number is 0x0dcb. Once the Identifier_Number_Selector is changed from "Profile
Specific" to "Manufacturer Specific" or vice-versa, you must wait 5 seconds while it is saved and the turn off
the FRI303 and then the identifier is updated in the level of communication. If the equipment is in "Profile
Specific" and using the GSD file Identifier Number equals 0x0dcb, the acyclic communication will work well
with tools based on EDDL, FDT/DTM, but no cyclic communication with the Profibus-DP master will get
success.