Smalvic FI-64ET, Installation, Use And Maintenance Instructions

Page: 64 / 106

62
writing on the glass surfaces must be as in (fig. 6). Also make
sure the protective gaskets are positioned correctly. Some
models have a clip (D) for anchorage of the glass, which must be
repositioned correctly (fig.7). Keep the clip D organised centrally
on the upper painted list of the door, insert the intermediate
transparent glass (E) into the relevant guides until the clip D
is blocked. Place the screen-printed glass F in the housing and
make it run until it blocks on the upper painted list.
Remount the two blocking plates (C Fig. 1) in the lower part of
the door maintaining the clip D against the stripe painted on the
upper part of the door, and inserting the intermediate glass E
and internal glass F in position (as shown in the figure).
Before remounting the door, make sure the glass is firmly
secured in place.
ATTENTION
The removal and installation must be carried out accurately
and with the highest care in order to avoid the breakage of
the glass.
ATTENTION
Do not remove the hinge stops from their seat when the
door is not mounted on the oven. Do not close the hinges
without the weight of the door since it causes a violent
closure of the springs.
Removal/ assembly of the lateral guides
Before proceeding, make sure that the oven is cool
Tightly grip the guide at the front, lift it until it blocks and pull the
front part towards the inside of the oven (fig.1) in a way that it
can release itself from its front seat.
Fig. 1
Fig. 2
Now, pulling towards yourself, the guide will slide for approx. 1
centimetre. Lift it and release it from its seat by pulling it inside
the oven cavity. (fig.2).
To re-mount the guides, perform the steps in reverse order
(Fig.3-Fig.4 )
ATTENTION
During this process do not rest weights or apply pressure on
the lateral guides. The enamel on the side walls of the oven
could be damaged.