Smalvic FI-36 VTB, Installation, Use And Maintenance Instructions

Page: 90 / 104

37
MAINTENANCE AND CLEANING
Disconnect the electric power supply before performing any type of maintenance
on the product
Do not use steam cleaners on the appliance.
Do not use rough, abrasive materials or sharp metal scrapers to clean the oven
door, as they can scratch or damage the surfaces and cause the glass to break. Do
not use acid products (like anti-scaling agents) as they can damage the enamelled
parts.
Turn off the heating elements, wait for the internal parts of the oven to cool down
before touching or cleaning them. Pay great attention to the cooking grills. Clean
the oven with care. Be careful to avoid steam burns if a sponge, or damp cloth,
used for cleaning residue, comes into contact with a hot surface. Moreover, some
detergents create noxious fumes on contact with the heat.
Regular maintenance
Periodically check the state of the rubber gasket located around the oven opening.
This guarantees correct functioning of the oven. If gasket damage is noted, contact
the nearest technical after-sales centre.
Cleaning the surfaces
The enamelled or stainless steel parts must be treated with caution. Use water or
specific products, drying thoroughly with a soft cloth. Do not use abrasive products.
In case of tough deposits on enamelled parts, use a plastic sponge or similar,
soaked in hot water and vinegar. If food residues or oil, sugar, grease stains, etc.,
are not immediately removed after use of the oven, they can become more difficult
to remove. It will make removing them easier if the internal parts of the oven are
cleaned while they are still warm.
Due to an increasing presence of new products on the market, it is impossible to
establish a list of items useful for cleaning this appliance. Read the manufacturer
instructions carefully to verify the possible use of the detergent.
Warning: screen printed symbols
The symbols stamped on the appliance (e.g. around the knobs) can be damaged if
dirt (food, oils, liquids, salts etc.) remain for an excessively long period on them.
Dirt residue must be removed immediately but use products specifically for steel
as other overly abrasive ones could cause the symbols to fade.
OPERATING ANOMALIES
In case of abnormal operation immediately contact the nearest qualified and
authorised technical service centre.