SMA SUNNY TRIPOWER 12000TL-US, Installation Manual

Page: 14 / 232

4 Product Description
4.1 Sunny Tripower
The Sunny Tripower is a transformerless PV inverter with two MPP trackers which converts the direct
current of the PV array to grid-compliant three-phase current and feeds it into the utility grid.
No galvanic isolation
• The product is not equipped with a transformer and therefore has no galvanic isolation.
Do not use grounded PV modules with the product. Only ground the mounting frame of
the PV modules. If you connect grounded PV modules to the product, the error message
Insulation resistance > Check generator occurs.
• The AC output/neutral conductor is not bonded to ground inside of the product.
Model SB X
XX
XXXTL
US-
SUNNY B
OY
S/N XXXXXXXXXX
Untility inter activ
e 1-phase in vert
er
Made in Ger
man y
SMA Solar T
echnology A
G
www
.sma-solar .com
Date of manufacture
MM/YYYY
Max. continuous output Power
*XXXX W
ac
Reduced output power rating
Operating voltage range (Vac)* MIN
NOMINAL
MAX
XXX XXX
XXX XXX
XXX XXX
Operating frequency ra
nge (Hz)*
MIN
NOMINAL
MAX
XX.X
XX.X
XX.X
Max. vontinuous output current*
XX.X A
ac @ XXX V
XX.X A ac @ XXX V
Output power factor X
Max. open circuit input voltage*
XXX Vdc
Range of input operating DC voltage (MPPT)* XXX - XXX Cdc @ XXX V
XXX - XXX Cdc @ XXX V Oper. temp. range
*-XXX°F to + XXX°F
(-XX°C to +XX°C)
This unit contains
a Residual
Current Monitor,
Isolation
Monitor
and Interrupter.
This unit contains
a listed
Photovoltaic
Arc-Fault Circuit-Protection
of Type
1
ENCLOSURE TYPE XR (IP54)
*For more details
and für tightening
torque,
allowable
wire size and
type see the
Installation Guide.
Section 1 of 2
Utility interactiv
e in verter
Liste t UL 1741 36AN
Utility interactiv
e 1-Phase in verter
Tested To Com
ply
Wit h FCC S tandards
FOR HOME OR
OFFICE USE
CCAN/CSA
C22.2 No. 107.1-1
UL1699B
DE34
A
G
H
E
D
F
A
B
C
F
www
.sunn ypor
tal.com/r egist
er
PIC 001800304600117
RID:37XXA3
D
Figure 2 : Design of the Sunny Tripower
Position Designation
A Thread for screwing in the eye bolts for transport with a crane
B Upper enclosure lid
C Type label
The type label uniquely identifies the inverter. You will require the information on
the type label to use the product safely and when seeking customer support from
the SMA Service Line. You will find the following information on the type label:
• Device type (Model)
• Serial number (Serial No.)
• Date of manufacture
• Device-specific characteristics
4 Product Description SMA Solar Technology America LLC
Installation Manual STPTL-US-10-IA-xx-17 14
ENGLISH