Decommissioning
SMA Solar Technology AG
36
SL6000-TEN081820
Technical Description
12 Decommissioning
12.1 Disassembly
1.
Open the Smart Load as described in section 8.1 "Opening the Smart Load" (Page 30).
2.
Disconnect the AC cable from the Smart Load.
3.
Disconnect the load resistor from the Smart Load.
4.
Remove the communication cable from the Smart Load.
5.
If necessary, disconnect additional connections from the Smart Load.
6.
Close the Smart Load. Establish the PE connection to the lid and tighten the lid on the
Smart Load using four screws.
7.
Remove the Smart Load.
12.2 Packaging
If possible, pack the Smart Load in the original packaging. If this is no longer available, you can
also use an equivalent box that fulfills the following requirements:
•
Suitable for loads of up to 14 kg
•
With handle system
•
Can be closed fully
12.3 Storage
Store the Smart Load in a dry place where the ambient temperature is always between -25 °C and
+50 °C.
12.4 Disposal
Dispose of the Smart Load at the end of its service life in accordance with the disposal regulations
for electronic waste which apply at the installation site at that time. Alternatively, send it back to
SMA with shipping paid by sender, and labeled "ZUR ENTSORGUNG" ("for disposal").
Summary of Contents for SMART LOAD 6000
Page 2: ......
