Repair Parts and Maintenance Guide
138
The information contained in this document is subject to change without notice.
BASYS
®
Infrared Sensor Activated
NOTE: Turning off water is not necessary, due to integrated automatic stop
valve.
Remove battery pack assembly by
lifting out of spout.
Rotate solenoid assembly counter-
clockwise through a 45º angle.
Pull solenoid caddy from faucet.
NOTE: STRAINER (FILTER) CAN
BE REMOVED, CLEANED AND
REPLACED AT THIS TIME.
Remove crown by loosening hex
screw located on underside of spout
and slide crown down and lift off.
NOTE: Screw is captive within
faucet body and will not fall out.
REPLACING THE SOLENOID STRAINER (FILTER)
UNLOCK
LOCK
Insert new solenoid caddy at a
45° angle.
Rotate solenoid caddy clockwise to
align with arrow, locking the unit
and opening water path.
Reinsert battery pack assembly.
Slide on crown and secure.
UNLOCK
LOCK
SPARE
FILTER
SPARE
FILTER
Faucets and Soap Dispensers
Repair Parts and Maintenance Guide
139
The information contained in this document is subject to change without notice.
Wait, until LED fl ashes GREEN.
2x +
1x 5 sec
1x
2x
3x
4x
6x - Factory Setting
7x
8x
5x
2x +
1x 5 sec
1x
2x
3x
4x
6x - Factory Setting
7x
8x
5x
2x +
1x 5 sec
1x
2x
3x
4x
6x - Factory Setting
7x
8x
5x
2x +
1x 5 sec
1x
2x
3x
4x
6x - Factory Setting
7x
8x
5x
BASYS
®
Infrared Sensor Activated
Factory setting is appropriate for the majority of applications and should not
require resetting unless under extreme situations.
IR Activation (see page 129).
To enter programming mode
place fi nger on IR clic for 2 times
then remove. Light on side of
crown should blink red to indicate
programming mode.
Cover IR clic until LED fl ashes 4x -
hold on until LED fl ashes 1x to 8x,
from minimum to maximum range.
See diagram below. Release when
requested range is reached.
SENSOR RANGE ADJUSTMENT
BATTERY REPLACEMENT
NOTE: Replace Battery when LED1 indicator fl ashes red each time faucet
is in use or when faucet stops functioning. LED1 is identifi ed by the battery
symbol.
NOTE: Turning off water is not necessary.
Loosen cover screw and remove
cover from battery pack.
Install four (4) AA-size batteries
(supplied) as indicated by the (+)
and (–) symbols inside the battery
compartment.
Replace battery pack lid and tighten
with screwdriver.
NOTE: Insure batteries are installed
with proper polarity. The cover
of the case indicates polarity of
batteries. Improper polarity will not
harm the faucet. Improper polarity
will cause the faucet not to operate.
Faucets and
Soap Dispensers
372626_Master_Book_ccg.indd 136
9/18/17 7:53 AM
