Sleipner SE20/110, Installation Manual

Page: 21 / 28

21
5611 12 2021
-
SE20 & SE25 & SE30 & SE40
MG_0031
6 1265 5-LEAD
Y-CONNECTOR
6 1265 5-LEAD
Y-CONNECTOR
6 1278-xxM 5-LEAD
CONTROL CABLE
6 1278-xxM 5-LEAD
CONTROL CABLE
6 1278-xxM 5-LEAD
CONTROL CABLE
6 1277-xxM 4-LEAD
CONTROL CABLE
6 1277-xxM 4-LEAD
CONTROL CABLE
STERN
BOW
STERN
BOW
STERN
6 1278-xxM 5-LEAD
CONTROL CABLE
Switch
5A fuse
Switch
5A fuse
Common negative
10A fuse
+
-
+
-
To define appropriate (-) cable
and fuse size contact a skilled
electrician
To define appropriate (-) cable
and fuse size contact a skilled
electrician
6 1274 4-LEAD
Y-CONNEC TOR
STERN
BOW
STERN
BOW
STERN
xA fuse
6 1277-xxM 4-LEAD
CONTRO L CABLE
6 1277-xxM 4-LEAD
CONTRO L CABLE
6 1277-xxM 4-LEAD
CONTRO L CABLE
6 1277-xxM 4-LEAD
CONTRO L CABLE
6 1274 4-LEAD
Y-CONNEC TOR
xA fuse
Common negative
10A fuse
+ +
- -
With Automatic Main Switch:
With Manual Main Switch:
IMPORTANT
Check the following with the main switch in the off position
After all electrical connections have been completed check with an ohm meter that there is
no electrical connection between electro motor body and positive terminal on the motor and
between the electro motor body and the negative (A1) terminal on the motor. If you feel
unsure about how to perform this check, contact skilled personnel for guidance
Common negative MUST be wired when using control panel 8940 and 8909C if separate
battery banks are installed. (Bow and Stern thrusters combined)
Visual Wiring Diagram
EN
Control Panel Cable Installation
EN
• All Sleipner control panels can be used in any combination.
• All control panels can be installed using:
• Y-connectors - for standard on/off
• T-connectors - for S-link proportional power system.
(NB: If two or more control panels are operated at the same time in opposite directions, the electronic control box will stop the thruster until
it receives a single signal or thrust in one direction.)
• Sleipner on/off equipment it is entirely “plug & play” and require no additional confi guration setup.
See the Control panel manual for more information.
MC_0041
! Please refer to the graphic for special considerations relating to your model !
MG_0024
Thruster
Motor
Ext. cable
4- or 5-lead
Y cable
4- or 5-lead
Ext. cable
4- or 5-lead
Option: Automatic main switch. connects the battery to
the thruster. Operated from the control panel(s).
Requires 5-lead control cables.