62
6463
2
2022
-
SPS-B
Fin Removal
REMOVING THE FIN
1. Take and record measurements of the distances from the aft end of the fi n to the keel and the fore end of the fi n to the keel.
2. Remove the shaft cover using a 4mm Allen key.
3. Loosen the nuts but do not remove them.
4. Remove the OFF port cover for the hydraulic port.
5. Attach the line into the port marked OFF. The fi rst adaptor is secured with a 22 spanner. The second part is secured with a 15 spanner.
6. Use the hydraulic pump until the fi n drops down but is held up by the nuts.
7. Use two people to take the weight of the fi n while you remove all the nuts and washers.
8. Lower the fi n to the floor and replace the protective shaft cap.
9. Replace the actuator port cover with rubber seal.
MC_0246
IMPORTANT
A hand oil pump (Installation tool kit, Item nr VFT55) must be used to achieve the fi n installation. The pump should only be operated by
qualifi ed personnel that follow the pump manual operating instruction and health and safety directives.
MG_0266
Keel
1
2
3
4
5
6
7 - 9
Off
Port