23
2933
4
2019
-
SH 240 & SH 320
Control Panel Installation
EN
Find a comfortable location for the control panel where it does not obstruct or is obstructed by other controls. Install the control panel where it is easy
to use.
(NB: As a guide the side thruster if often operated together with the gear/throttle control. For the optimal user-friendly solution install
the control panel where access to both controls are accessible with one hand for each control.)
1. Use the enclosed cut-out template to mark the area to remove on your control dash.
2. Cut out the area per template for the control panel. (
NB: If the front surface around your cut out is jagged or chipped, use a sealant
to assist the gasket.)
3. Place the gasket to the back face of the panel
4. Plug cables into the connectors at the rear of the control panel.
(NB: Twist the locking ring on the connector clockwise to secure connector.)
5. Insert the control panel in place and fasten screws.
6. insert the control panels covering caps.
MC_0042
!
Please refer to the graphic for special considerations relating to your model
!
MG_0063
GASKET
4x SCREWS
58 mm
67 mm
125 mm
116 mm
132.7 mm
75.7 mm
Ø 4.5 mm
Ø 4.5 mm
Ø 4.5 mm
Ø 4.5 mm
(S-link)
External alarm buzzer
12V / 24V DC - max 0,5A
External alarm / buzzer connection
Supply
+ 12V / 24V DC
-
+
Ø 4.5 mm
Rear
side
of pa
nel
Internal
fuse / relay