4. Place the machine on top of the Pneumatic Control Box. Your machine comes with a braid of
two tubing. One has a label "Upper" and the other has a label "Lower." Insert the two tubing
into the back of the Pneumatic Control Box. ("Upper" to "Upper", "Lower" to "Lower".)
5. Plug the machine, the Pneumatic Control Box and the compressor into the proper electric
outlet and turn on the power switches.
6.Allow time for the air pressure to build up in the compressor.
7.Set the pressure needed for imprinting on the Pressure Regulator. Pull the round knob upward,
then turn to set pressure. Press the knob down when finished.
8. Your air-operated SLE Hot Printer is now ready for operation.
Loading Foil
Depending on your specific model, the SLE Hot Printer is designed to accommodate foils from one
to six-inch width. The foil is automatically advanced with each impression.
1. Remove the outer Foil Holding Socket from the Rear Foil Bracket by turning it clockwise and
pulling outward.
2. Remove the outer plastic Foil Holding Disc. Leave the inner disc on the Rear Foil Bracket.
3. Remove the label from the foil and mount the foil onto the Rear Foil Bracket with the foil
unwinding downward from the front of the roll.
4. Replace the outer Foil Holding Disc.
5. Replace the outer Foil Holding Socket to lock the foil in place by pushing the Socket in along
the groove and turning it counter-clockwise.
6. Center the foil by adjusting the position of the inner and outer Foil Holding Sockets.
7. Slip the foil under and around the Foil Guide Bar with the aid of a pencil. Pull the foil
towards the front of the machine. At this point check to verify that the dull side of the foil is
facing downward. (If the shiny side is facing downward instead, go back to step 3 and mount
the foil in the reverse direction.)
Foil Holding
Foil Holding Socket
Rear Foil Guide
Foil with Shiny Side
