18
V-ring
Align opening of enclosure
as shown here, centered in
between the legs of the
trampoline.
Spring
Jump mat
7
3.
Attach the Jump Mat to the trampoline frame by refer-
ring to steps 4-5 in the trampoline assembly
Be sure to place the door opening in the enclosure net-
ting so it is centered in between the two legs of the tra-
mpoline where the jumpers will climb off and onto
the trampoline easily as shown.
Trampoline
frame
Spring
3
4
4
. Attach the Frame Pad to the trampoline frame. Refer to
step 6-7 13 in trampoline assembly for further instruction
Note
: There is a Hexagon hole on the pole cap (1) with a nut
inside as shown A. Insert the pole cap(1) though one strap
ring on the top edge of the enclosure mesh(7) as shown in
Inset Drawing B.
Make sure the Hexagon hole side of the
cap is against the mesh, and the holes on both the strap ring
and the caps are aligned.
Hold the pole cap close to a curved tube (6) with foam as shown
in Inset Drawing C. Insert the curved tube(6) into the pole
cap.
Make sure the holes on the curved tube
,
pole cap
and strap ring are aligned.
Insert the M5x50mm bolt(2)
until it touches the nut in the Hexagon hole of the pole cap,
securing them together.
Repeat this process to assemble the rest of the pole caps(1)
to the curved tubes(6) with foam by the same manner.
Inset drawing
C
Holes
B
1
7
Strap ring
Strap
6
1
Hole
2
Hole
A
1
Hexagon hole
Enclosure Door
6
6
6
6
Frame Pad
