REV. 12/26/13 Page 5 of 6
Skytech SKY-MRCK-TH (SR 1001TH-1)
NOTE
: Up to 6 VDC of power is provided at the receiver terminal.
GENERAL INFORMATION
LEARNING TRANSMITTER TO RECEIVER
Each transmitter uses a unique security code. It will be necessary to press the LEARN button on the receiver to accept the transmitter
security code upon initial use, if batteries are replaced, or if a replacement transmitter is purchased from your dealer or the factory. In
order for the receiver to accept the transmitter security code, be sure the slide button on the receiver is in the REMOTE position; the
receiver will
not
LEARN if the slide switch is in the ON or OFF position. The LEARN button in located on the front face of the receiver;
inside the small hole labeled LEARN. Using a small screwdriver or end of a paperclip gently press the black LEARN button inside the
hole and release the button. When you release the LEARN button the receiver will emit a “beep”. After the receiver emits the beep
press the transmitter OFF button and release. The receiver will emit several beeps indicating that the transmitter’s code has been
accepted into the receiver.
A microprocessor controls the security code (learning process) that is controlled by a timing function. If you are unsuccessful learning
the security code on the first attempt, wait 1 – 2 minutes before trying again - - this delay allows the microprocessor to reset the timer
circuitry - - and try up to two or three more times.
CHILDPROOF (CP) FEATURE
This remote control includes a CHILDPROOF “LOCK-OUT” feature that allows the user to “LOCK-OUT” operation of the appliance,
from the TRANSMITTER.
SETTING “LOCK-OUT” –(CP)
•
To activate the “LOCK-OUT” feature, press and hold the ON/HI button and the MODE button at the same time for 5 seconds. The
letters CP will appear in the TEMP frame on the LCD screen.
•
To disengage the “LOCK-OUT”, press and hold the ON/HI button and the MODE button at the same time for 5 seconds and the
letters CP will disappear from the LCD screen and the transmitter will return to its normal operating condition.
•
To verify that transmitter is in the CP lock-out mode press any button and the LCD screen will show “CP”
NOTE
: If the appliance is already operating in the ON or THERMO MODES, engaging the “LOCK-OUT” will not cancel the operating
MODE. Engaging the “LOCK-OUT” prevents only the manual operation of the TRANSMITTER. If in the auto modes, the THERMO
operation will continue to operate normally. To totally “LOCK-OUT” the operation of the TRANSMITTER’S operating signals; the
transmitter’s MODE must be set to OFF.
O
N
OFF
P
IL
O
T
IG
N
OFF
ON
1/4” Male
Terminal
HI/LO STYLE SERVO
MOTOR VALVE
7/32” Male
Terminal
Pilot Adjustment
