REV. 12/26/13 Page 4 of 6
Skytech SKY-MRCK-TH (SR 1001TH-1)
FUNCTIONS:
•
With the slide switch in the ON position (toward the LEARN button), the system will
remain ON until the slide switch is placed in the OFF or REMOTE position.
•
With the slide switch in the REMOTE position (centered), the system will only
operate
if the remote receiver receives commands
from the transmitter.
•
With the slide switch in the OFF position (away from the LEARN button), the system
is OFF.
•
It is suggested that the slide switch be placed in the OFF position if you will be
away from your home for an extended period of time. If the remote receiver is
mounted out of children’s reach, placing the slide switch in the OFF position
also functions as a safety “lock-out” by both turning the system off and
rendering the remote receiver inoperative
INSTALLATION INSTRUCTIONS
WARNING
DO NOT CONNECT REMOTE RECEIVER DIRECTLY TO 110-120VAC POWER. THIS WILL DAMAGE
THE RECEIVER AND RENDER INOPERABLE. FOLLOW INSTRUCTIONS FROM MANUFACTURER
OF GAS VALVE FOR CORRECT WIRING PROCEDURES. IMPROPER INSTALLATION OF
ELECTRIC COMPONENTS CAN CAUSE DAMAGE TO GAS VALVE AND REMOTE RECEIVER.
INSTALLATION
The remote receiver can be mounted on or near the fireplace hearth. PROTECTION FROM EXTREME HEAT IS VERY IMPORTANT.
Like any piece of electronic equipment, the remote receiver should be kept away from temperatures exceeding 130ºF inside the
receiver case. Battery life is also significantly shortened if batteries are exposed to high temperatures.
HEARTH MOUNT
The remote receiver can be placed on the fireplace hearth or under the fireplace, behind
the control access panel. Position where the ambient temperature inside the receiver
case does not exceed 120º F.
NOTE
: Black Button (Receiver Slide Button) is used on Hearth Mount Applications.
WIRING INSTRUCTIONS
CONNECTING THE RECEIVER TO A HI/LOW SERVO MOTOR STYLE VALVE SYSTEM
1. Connect the BLACK 18 gage stranded wire with the 1/4” female terminal from the receiver to the 1/4” male terminal on the valve
servo motor.
2. Connect the RED 18 gage stranded wire with the 1/4” female terminal from the receiver to the 7/32” male terminal on the valve
servo motor.
NOTE:
The 1/4” female terminal may need to be replaced if your connection does not adequately fit the 7/32”
terminal.
3. After receiver wires are connected to the valve servo motor terminals make sure the receiver shield is located over the receiver and
then locate the receiver in an area that will not exceed the 130° F.
4. Depending on the product that this remote control system is used on, the 1/4” female terminal and wire from the receiver and the
7/32” female terminal and wire may need to be cut to a shorter length. This can be done by removing the (2) wires from the receiver
cutting them to the desired length then reinstalling them into the same connections on the receiver.
IMPORTANT NOTE:
Operation of these controls is dependent on which wire is attached to which terminal. If operation of control
does not correspond to operating buttons on transmitter, reverse wire installation at the receiver or at the control.
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN
Wire terminals
Remote Receiver
Receiver
Slide
Button
REMOTE
OFF
ON
LEARN
