PERIOD
MORN
DAY
EVE
NIGHT
TIME TEMP
TIME TEMP TIME TEMP
TIME TEMP
S
(Sunday)
M
(Monday)
T
(Tuesday)
W
(Wednesday)
T
(Thursday)
F
(Friday)
S
(Saturday)
STEP 2
: To program the
START TIME
, press the UP or DOWN
buttons to set the hour corresponding with the AM/PM time
period. Start time settings are in 15 minutes segments. When
desired START TIME is displayed press the PROG button and
the
SET
temperature will blink on the LCD screen.
DOWN
UP
MODE
SET
PROG
AHEAD
BACK
TIME
TIMER
COVER OPEN
STEP 3:
To program the
SET
TEMPERATURE
, press the
UP or DOWN butttons. When desired SET temperature
displays, then press the PROG button.
After pressing the PROG button the next
PERIOD
of the
same or next day will display (not blink) on the LCD screen
(Fig. 23).
Fig. 21 Setting TIME of Program
Fig. 22. Set Temperature
Fig. 23 Period of Day
To program the next Period of Day follow steps 1 through 3 recording them on the blank table below until all (7) days and
the (4) time periods in each day are programmed.
Once ALL the programming has been completed, then press the SET button on the transmitter. The programming data
you entered will now over-ride the factory built-in program and operate your system.
PROGRAMMING NOTE:
Once you are in the programming process, if you only want to program only specific days you can bypass the DAYS and
PERIOD of DAY by pushing the AHEAD or BACK buttons. This eliminates the need to enter the TIME and TEMPERA-
TURE for specific each DAY and PERIOD speeding up the programming process. Once the LCD screen displays the
specific DAY and PERIOD of DAY you want to program press the PROG button and following the steps above.
PROGRAM REVIEW
If you want to review the settings for the FACTORY BUILT-IN program or your customized program, you may do so by
pressing the PROG button for one second at a time. To review each setting then press the PROG button one second be-
tween each period of day. Press the SET button when finished reviewing to return to normal operation.
PROGRAM CANCELLATION
If you want to cancel the CUSTOMIZED program you entered and return to the FACTORY program do the following:
STEP 1:
Press the SET button to ensure the LCD screen is in the normal state.
STEP 2:
Press and hold the PROG and SET buttons “
at the same time”
for 10 seconds.
STEP 3
:
The customized programs will be cancelled and the LCD screen will begin blinking the START, FOR, TIME and
SET temperature confirming the customized programs have been cancelled.
STEP 4
: Push the SET button to return the normal LCD screen or wait 10 seconds and it will return automatically.
Fig. 24 Blank table to record custom programming
Skytech: 3301P
REV. 2-7-12 Page 9
